How do I adjust the size of my MagnetMD® Metal bracelet?
Need to loosen or tighten your therapeutic bracelet? Simply use the complimentary sizing tool that comes with your purchase to add or remove links that perfectly match your wrist!
Watch the Video Below To Resize Your Metal Bracelet:
Use this to guide your metal link resizing needs:
1: Wrap the bracelet over your wrist so you’ll have an idea about how many links you need to add or remove.
2: Look for the round end on the side of your bracelet. Make sure you’re on the side that has a round & indented end, not the flat side with a slit in the middle.
This round end has a needle inside the bracelet link. Strike this rounded point with the tool pin.
The needle inside the bracelet link has two sides: (1) a rounded & indented end and (2) a flat end with a slit in the middle.
3: Twist open the sizing tool & place your bracelet over it.
4: Once it is properly aligned, twist the knob until the needle pops out.
5: To remove the bracelet, twist the knob in the opposite direction. Then, using your fingers, finish pulling the needle out.
6: Repeat the process & remove any links until it fits your wrist.
7: Insert the needle using your fingers while holding the two bracelet links together.
8: Make sure you insert the needle on the right side — the smaller round needle end.
9: Push against the sizing tool’s base or a hard surface to ensure the pin is perfectly flat with the rest of the bracelet links.
10: IMPORTANT: If the pin breaks on your sizing tool when trying to remove a link watch this video. There are two extra pins in the bottom of the tool.